Q-2, r. 15 - Regulation respecting mandatory reporting of certain emissions of contaminants into the atmosphere

Section 7.1 Disposition versions

2020-01-01

7.1. Any device, system or equipment required under this Regulation must be maintained in good working order and operate optimally during operating hours.

In addition, unless otherwise provided for in one of the protocols in Schedule A.2, the equipment of an emitter referred to in section 6.6 used to measure the parameters required to calculate greenhouse gas emissions subject to the verification or the calculation of the quantity of reference units must be calibrated according to the manufacturer’s instructions in order to maintain accuracy of plus or minus 5%.

If the emitter is unable to obtain the manufacturer’s calibration instructions, the emitter must establish and use a procedure allowing to maintain accuracy of the equipment of plus or minus 5% The procedure must have been certified by an engineer.

M.O. 2010-12-06, s. 10; M.O. 2012-09-05, s. 7; M.O. 2013-12-11, s. 10; M.O. 2019-12-05, s. 3.

2014-01-01

7.1. Any device, system or equipment required under this Regulation must be maintained in good working order and operate optimally during operating hours.

In addition, unless otherwise provided for in one of the protocols in Schedule A.2, the equipment of an emitter referred to in section 6.6 used to measure the parameters required to calculate greenhouse gas emissions subject to the verification or the calculation of the quantity of reference units must be calibrated according to the manufacturer’s instructions in order to maintain accuracy of plus or minus 5%.

M.O. 2010-12-06, s. 10; M.O. 2012-09-05, s. 7; M.O. 2013-12-11, s. 10.

2013-01-01

7.1. Any device, system or equipment required under this Regulation must be maintained in good working order and operate optimally during operating hours.

In addition, unless otherwise provided for in one of the protocols in Schedule A.2, the equipment used to measure the parameters required to calculate greenhouse gas emissions or the quantity of reference units must be calibrated according to the manufacturer’s instructions in order to maintain accuracy of plus or minus 5%.

M.O. 2010-12-06, s. 10; M.O. 2012-09-05, s. 7.

2012-09-01

7.1. Any device, system or equipment required under this Regulation must be maintained in good working order and operate optimally during operating hours.

M.O. 2010-12-06, s. 10.